◎ 型號含義 Type meaning
① 1 路 One channel
② 控制電壓 3-32VDC Control voltage 3-32VDC
③ 直流控直流 DC-DC (DC input-DC output)
④ 負載電壓 5-220VDC
Load voltage 5-220VDC
⑤ 10A, 20A, 25A, 30A, 40A, 50A, 60A, 75A, 80A,90A,100A
◎ 產品概述 Product overview
◆ 直流固態繼電器易并聯，適合大電流應用場合
◆ 額定電流：10A-100Amps
◆ 額定電壓：5-220VDC
◆ 控制電流：≤ 40mA
◆ 低輸出斷態漏電流
◆ 低阻抗 MOSFET 輸出，限度減少總功耗
◆ 適合阻性負載和感性負載 ( 感性負載如電機和 EMR/電磁線圈等必須加裝抑制二極管 )
◆ 具有 LED 燈輸出指示
◆ 包含標準輸出的 R-C 緩沖器
◆ 透明保護蓋為用戶提供額外保護
◆ DC solid state relays are easy to connect inparallel, suitable for high current applications
◆ Rated current: 10A-100Amps
◆ Rated voltage: 5-220VDC
◆ Control current: ≤ 40mA
◆ Low output off-state leakage current
◆ Low-impedance MOSFET as the outputcomponent minimize the total power consumption
◆ Suitable for resistive load and inductive load(the inductive load, such as motor and EMR /electromagnetic coil, must be equipped with thesuppressor diode)
◆ Display output status via LED
◆ Standard output R-C buffer
◆ Transparent cover for extra protection
注意 :
1. 當負載電流為 10A 時 , 必須加裝散熱器 ; 為 40A 及以上時 , 必須加風扇強冷或水冷 .
2. 使用感性負載時 , 務必在輸出端并接一個壓敏電阻 , 取值為負載電壓的 1.6-1.9 倍 .
Notice:
1. If the load current is 10A, a heat sink must be equipped; if the load current is 40A or more, an air-cooled radiator or a water-cooled radiator must be installed.
2. When the load is an inductive load, be sure to connect a varistor in parallel with the output terminal, whose voltage value is 1.6-1.9 times the load voltage.
◎ 安裝尺寸及接線圖 Installation dimensions and wiring diagram
注：特殊電壓可定做。Note: Specific voltage can be customized.
網站客服
